Skip to content
English
  • There are no suggestions because the search field is empty.

Connect C-Pen Reader 3 and C-Pen Lingo 3 to Oticon hearing aids

Bluetooth hearing aids typically use a specific way of communicating via Bluetooth, called ASHA. This is different from the way ordinary Bluetooth headsets work.

To solve this, and enable use of C-Pen Reader 3 and C-Pen Lingo 3 with your Oticon hearing aids, you can use their ConnectClip.

How to connect C-Pen Reader 3 and C-Pen Lingo 3 with your Oticon hearing aids

To connect C-Pen Reader 3 or C-Pen Lingo 3 to Oticon hearing aids, use an Oticon ConnectClip as a Bluetooth bridge. Hearing aids use the ASHA protocol rather than standard Bluetooth, so a direct connection is not possible without ConnectClip. Complete the two stages below: first pair your hearing aids with the ConnectClip, then pair the ConnectClip with your C-Pen device.

Pairing your hearing aids with ConnectClip

  1. Power off ConnectClip: press and hold the multi-button for approximately six seconds until the power indicator turns off.

  2. Turn your hearing aids off.

    • For hearing aids with disposable batteries, open the battery drawer.

    • For rechargeable hearing aids, press the lower button of each hearing aid for three seconds.

  3. Turn your hearing aids on.

    • For hearing aids with disposable batteries, close the battery drawer.

    • For rechargeable hearing aids, press the lower button of each hearing aid for two seconds, or place them in the charger and then remove them.

The hearing aids are now ready for the first connection with the ConnectClip. You now have three minutes to complete the pairing.

  • Turn ConnectClip on: press and hold the multi-button for approximately three seconds until the power indicator shows steady green. ConnectClip will now search for your hearing aids; the status indicator will blink yellow.

  • Establish a connection: place ConnectClip within 20 cm of your hearing aids. A steady yellow status indicator confirms a successful connection.

  •  

     

    How do you pair ConnectClip with your C-Pen Reader 3 and C-Pen Lingo 3?

    1. Put ConnectClip in phone pairing mode: press and hold the multi-button and the volume up button simultaneously for about six seconds until the status indicator blinks blue. ConnectClip will remain in pairing mode for about three minutes.

    2. On your C-Pen Reader 3 or Lingo 3, ensure that Bluetooth® is turned on in Settings.

    3. Search for and select ConnectClip in the list of available Bluetooth devices.

    4. If prompted for a PIN code, enter 0000.

    5. Pairing is complete when the ConnectClip status indicator shows steady blue.